Had loads of fun working on this today, but did find it very finicky going. I think part of the problem was the eraser I was using. It’s a very soft plastic one and I found it very very easy to cut too far. The design I was working on was supposed to be 43T with a thick border line around it. Unfortunately I slipped and one edge of the border was no more … so I had to remove the rest as well.
The end result wasn’t too bad though, I’m pleased with it as a first effort and will use the lessons learnt when I attack the next one.
The photo shows my test stamps as I went. The ones on the left are the earlier ones and showed me which areas needed more trimmed away. The ones on the right are the finished result.

